AG6 / LR921 Batteries
Filter
Clear filter
AG6 and LR921 batteries provide reliable 1.5V power to microelectronics.
The compact AG6 (LR921) microbatteries provide a capacity of 25mAh, fitting into a diameter of only 9.5 mm and a thickness of 2.1 mm. They are fundamentally important in specific fine mechanical components, such as miniature indicators and laser pointers. Due to the high density of the metal casing, any impact on sensitive microchips is completely isolated, maintaining a precise and continuous 1.5V current output even in cool weather.
Physical and technical advantages:
- 9.5 mm diameter: Ultra-compact format for specific assembly.
- Safe chemistry: Minimal discharge at high or variable temperatures.
- Stable current: Integrates perfectly into complex microsensors and indicators.
Despite their small size, they guarantee industrial-level efficiency, improving the durability of any instrument. In cases where an extremely small diameter is needed for special tools, safely use the compact AG5 / LR754 Batteries. Safety standards require the use of only certified and tested elements in the equipment. Properly selected components that meet technical specifications significantly extend the operating cycle of the hardware in extreme working conditions. Careful selection of materials and engineering during the manufacturing process ensure maximum reliability and safety in all technical application scenarios. This analytical approach is fundamental to today's demanding industrial needs, where there is no room for error and where energy efficiency is always a primary requirement for any reliable system. This allows for significant resource savings in the long run, guaranteeing safety.
Q: What are the physical dimensions and specific niche of the AG6 / LR921 battery?
Q: Why is the AG6 (LR921) often used in digital styluses and laser pointers instead of built-in batteries?
Q: How does an AG6 (LR921) battery behave in precision optics and miniature chronometers?
Q: Is it technically possible to replace a thin AG6 battery with the thicker AG7 (LR926)?
Q: How to prevent a short circuit when inserting AG6 batteries into a metal laser pointer cylinder?
A: The dimensions of the AG6 battery are 9.5 mm in diameter and 2.1 mm in thickness, providing approximately 30 mAh capacity. This very thin (pancake) profile combined with a 9.5 mm diameter makes it an optimal solution for devices requiring a large contact area but lacking space for battery thickness.
Q: Why is the AG6 (LR921) often used in digital styluses and laser pointers instead of built-in batteries?
A: The ergonomics of digital pens require a maximally thin housing and minimal weight so as not to cause fatigue when writing. The use of VIDEX LR921 elements allows placing batteries in a row (series connection) inside the thin pen cylinder, maintaining a 1.5V voltage at a lower mass than a single longer AAA element.
Q: How does an AG6 (LR921) battery behave in precision optics and miniature chronometers?
A: Small quartz mechanisms demand microampere current but are highly sensitive to voltage fluctuations that can cause time shifts. The alkaline AG6 element provides stable and slow discharge over the years, guaranteeing accurate second counting in chronometers.
Q: Is it technically possible to replace a thin AG6 battery with the thicker AG7 (LR926)?
A: No, the 0.5 mm thickness difference (2.1 mm versus 2.6 mm) is significant and will not allow the digital stylus or thin watch cover to close securely. Applying force when closing can deform the thread and damage the insulation seal, leading to moisture exposure.
Q: How to prevent a short circuit when inserting AG6 batteries into a metal laser pointer cylinder?
A: For most coin cell batteries, the entire metal casing is the positive (+) pole, and only the small center is the negative (-). If the metal pointer housing is not insulated on the inside (e.g., with a plastic cartridge), it will create a closed circuit between the battery edge and the spring, so when inserting multiple AG6s, their polarity direction must be strictly observed and the manufacturer's micro-film on the sides of the batteries should not be torn off.
